Verint V15 - Cisco JTAPI Ports

Verint V15 - Cisco JTAPI Ports

The following TCP ports are used for Cisco JTAPI communication:
  • 2748: Used for JTAPI connection
  • 2749: Used for secure JTAPI connection
  • 2789: Used for JTAPI connection
  • 11200: JTAPI service registration port 

    • Related Articles

    • Verint V15.2 - SNMP Engine ID

      When configuring SNMO v3, you may be asked to provide the Engine ID. In the context of Verint systems (or any SNMP-enabled device), an "SNMP Engine ID" refers to a unique identifier string used in SNMPv3 protocol to securely identify each individual ...

    • Verint V15.2 - Add Insight Center Chrome extension without internet access

      How to install Insight Center Chrome Extension Without Internet Access KA37679 | Updated 18 days ago Public Safety Customer PS Desktop How To This article, KA37679, was previously referenced as article KM2983363. Audience Customer Description When ...

    • Verint V15.2 - AudioCodes Telephony Card Missing Firmware

      Description When LD, DP or DT cards are missing firmware the card will not be seen in Recorder Manager > General Setup > Voice Cards. Applies To Version15.2 FP0 Instructions 1. Stop Watchdog and TDM Capture Engine 2. Open ...

    • Verint V15 - Test and Acknowledge alarms

      Test and acknowledge alarms from the Alarm Testing notification profile An Alarm Testing profile is available to test that the alarm system is working properly. From the Alarm Testing profile you can raise and acknowledge four test alarms. The four ...

    • General - Call recording via Ring Central Eventide NexLog DX

      Recording for Ring Central is a non-traditional (Non-Standard) configuration. Ring Central Spans their own traffic through a port and then to the recorder. We start with the Configuration of the Capture NIC. Verify and confirm the IP to be assigned ...